Kenko Teleplus MC 1.4 PRO 300 DG, Canon

Kenko PRO 300 3.0x Placed between the camera body and lens, a teleconverter contains a set of optics that will effectively increase the focal length of a lens by a specific amount. Common magnifications are 1.4 times and 2 times, but the Kenko Teleplus PRO 300 AF converter has a 3x magnification. For example, using a 3 times (3x) teleconverter will increase the focal of 300mm lens to 900mm. The Teleplus PRO 300 converter is made with high quality multicoated optical glass supplied by Hoya Corporation, the worlds largest manufacturer of optical glass. The PRO 300 3x is designed for use with lenses of 50mm or above and work best with telephoto lenses of 100mm to 500mm. The PRO 300 3.0x can be used with telephoto zoom lenses as well as prime lenses. However, Kenko does not recommend them for lenses that have a zoom range that starts under 50 mm. KENKO PRO 300 AF Teleplus converters have genuine Gate Array IC (Integrated Circuitry). It means that the converter’s unique circuitry maintainS signal integrity between the camera body and lens. These converters are designed to electronically operate the same way an original manufacturer’s converter would provided there is enough light available. Important Note: Due to the 3 stop light loss inherent in a 3x converter, Kenko states that the PRO 300 3.0x converter will not auto focus with lenses that have a smaller aperture than f2.8. With all lenses having apertures smaller than f2.8, Kenko recommends using the PRO 300 3x in manual focus mode. Kenko PRO 300 2.0x and 1.4x KENKO Teleplus Pro 300 converters are made with precision quality multicoated optical glass supplied by Hoya Corporation, the worlds largest manufacturer of optical glass. These glass elements were designed to match the optical quality of the prime lens (even at the edges) and telephoto zoom lenses. The optical design of the elements and light path is wide enough not to cause vignetting. The PRO 300 family are designed specifically to be used with prime telephoto lenses of 100mm or above, such as the Tokina AT-X 300 AF PRO, 300 mm f2.8 lens, and work best with telephoto lenses of 200mm to 500mm. The PRO 300 can be used with telephoto zoom lenses as well as prime lenses. However, Kenko does not recommend them for zoom lenses that have a range starting under 50 mm. KENKO PRO 300 AF Teleplus converters have genuine Gate Array IC (Integrated Circuitry). It means that the converter’s own unique circuitry maintains signal integrity between the camera body and lens. These converters are designed to electronically operate the same way as an original manufacturer’s converter.1 Full AF operation with PRO 300 2.0x is possible when using camera lenses with maximum aperture of F2.8 or brighter. Please be aware that AF will work properly only if there is enough light and contrast on the subject to activate the camera’s AF sensors. (Manual focusing is required when using lenses with smaller maximum f-stop value than those given above.) With the PRO 300 1.4x, full AF operation is possible with camera lenses having a maximum aperture of F4 or brighter. The same light and contrast requirements apply. 1. Most Canon EOS camera bodies are programmed to shut down auto focus if the calculated effective aperture for the lens and teleconverter is smaller than f5.6, the Kenko Teleplus PRO 300 converters work the same way.